... | ... | @@ -2,4 +2,16 @@ watch out for Imperial VS metric collets and bits. 6mm IS NOT the same as 1/4". |
|
|
|
|
|
* [end mills guide](http://makezine.com/2014/09/10/endmills/)
|
|
|
* [VCarve Pro tutorials](http://support.vectric.com/tutorials/V8/VCarveProCategoryIndex.html)
|
|
|
* [Core77 ShopBot youtube playlist](https://www.youtube.com/playlist?list=PLg895GUKS5qjSGNSYVmnf2fv2pA0OVRKN) |
|
|
\ No newline at end of file |
|
|
* [Core77 ShopBot youtube playlist](https://www.youtube.com/playlist?list=PLg895GUKS5qjSGNSYVmnf2fv2pA0OVRKN)
|
|
|
|
|
|
|
|
|
**Zeroing Z axis**
|
|
|
1. Install the cutting bit.
|
|
|
2. Connect zeroing plate to the machine
|
|
|
3. Connect alligator clip to the spindle nut
|
|
|
4. Test connection by touching the cutting bit with the zeroing plate - in the ShopBot control panel "Input 1" should light up.
|
|
|
5. Place the zeroing plate under the cutting bit.
|
|
|
6. Press "Z zeroing" button on ShopBot control panel.
|
|
|
7. Wait for the zeroing routine to complete.
|
|
|
8. Disconnect and remove the zeroing plate from the machine.
|
|
|
|