... | ... | @@ -93,17 +93,18 @@ |
|
|
10. select correct printer - "Epilog Engraver"
|
|
|
11. go to "Setup - > Preferences"
|
|
|
12. adjust your settings
|
|
|
13. press ok and go back to print dialog
|
|
|
14. press "Print"
|
|
|
15. make sure the job arrived to the laser.
|
|
|
16. turn on exhaust
|
|
|
17. turn on air assist
|
|
|
18. triple-check everything is on and focused and there's nothing obstructing laser head moving
|
|
|
19. press "Go"
|
|
|
20. WATCH THE JOB UNTIL COMPLETION
|
|
|
21. once the job is done - wait 10 seconds before turning off exhaust and air assist to allow fumes to be properly removed
|
|
|
22. open the machine and VERY CAREFULLY remove your pieces
|
|
|
23. CLEAN THE WORKTABLE
|
|
|
13. change "Piece Size" to laser cutter bed size, which is 1000x600mm
|
|
|
14. press ok and go back to print dialog
|
|
|
15. press "Print"
|
|
|
16. make sure the job arrived to the laser.
|
|
|
17. turn on exhaust
|
|
|
18. turn on air assist
|
|
|
19. triple-check everything is on and focused and there's nothing obstructing laser head moving
|
|
|
20. press "Go"
|
|
|
21. WATCH THE JOB UNTIL COMPLETION
|
|
|
22. once the job is done - wait 10 seconds before turning off exhaust and air assist to allow fumes to be properly removed
|
|
|
23. open the machine and VERY CAREFULLY remove your pieces
|
|
|
24. CLEAN THE WORKTABLE
|
|
|
|
|
|
|
|
|
## Preparing your files for laser cutting / engraving
|
... | ... | |