Skip to content

Ultimaker · Changes

Page history
note about small pieces and vector table authored by Konstantin Leonenko's avatar Konstantin Leonenko
Show whitespace changes
Inline Side-by-side
Ultimaker.md
View page @ 92f3ee68
......@@ -8,7 +8,7 @@ Call them on the phone. DO NOT attempt to repair a machine on your own. If it is
1. export your model as an ".stl" file from your CAD package.
2. load the ".stl" file into [Cura](https://ultimaker.com/en/products/cura-software) software
3. [tune your settings](https://ultimaker.com/en/resources/20407-first-use-cura-2) (layer thickness, infill, wall thickness, supports, etc.)
4. check your model in layer view and make sure your output is in line with your expectations (supports are where you want them to be, wall thickness and infill are appropriate, brim/raft is positioned correctly, etc.)
4. check your model **in layer view** and make sure your output is in line with your expectations (supports are where you want them to be, wall thickness and infill are appropriate, brim/raft is positioned correctly, etc.)
5. check your print time and make sure it's reasonable and in line with your 3D printing experience. Basic rule of thumb - your first print should not be longer than 30 minutes, and every following one can double the time.
6. save your print to the SD card
7. put the card in the printer
......